GYS Exafeed 4L DIY shaft into an oil drainer Tools Allied Cargoloc shaft into an oil drainer for pit or under hoist use Sound warning: When reversing Designed to work exclusively with EXAGON generators the EXAFEED 4L wire feeder allows full control of welding parameters Its intuitive interface and its high precision wire feed are ideal for industrial customersOPTIMUM MIG MAG SETTINGS Voltage Wire speed and Inductance can be set from the front panel Set the trigger mode 2T and 4T Spot modes SPOT and SPOTDELAY 5 advanced settings Pregas Hotstart Creep speed Burnback and PostgasINTENSIVE USEHigh duty cycle 500A 60Compatible with air and water cooled torchesPowerful wheel drive system 100W with electronic regulation4 Drive rolls ensures effective wire feed with any wire typeERGONOMICDisplays currentvoltage during and after welding WPSPQRAdvanced display visible even in bright lightSimple interface large controls can be adjusted with gloved handsInternal LED light illuminating the wire feeder and wire reel50 settings can be memorisedLockable keyboard to protect against misuseCompatible with PushPull torch 24V 42VIntegrated torch supportMultiposition slinging support optionalROBUST AND MOBILEReinforced metal case amp non slip rubber padsIP 23 classification for outside use4 ringsbrackets for slingingInterconnection cables air or water up to 20m optionalWheels or support pads for enhanced mobility optionalSettings can be adjusted with a 10m cabled remote control optional